Elija el lugar de entrega

La selección de la página del país/región puede influir en varios factores como el precio, las opciones de envío y la disponibilidad del producto.

Ver todas las localizaciones

Ir a www.igus.com

Novedades 2024 - 247 innovaciones con motion plastics

Sin mínimos de compra

Expo virtual y tour por nuestra fábrica en Alemania

Envío en 24 horas Cálculo de la vida útil Descarga directa de CAD

myigus

Carrito de la compra

(0)

Mi persona de contacto

igus® México S. de R.L. de C.V.

Boulevard Aeropuerto 160

Col. Corredor Industrial Toluca-Lerma

Toluca, C.P 52004

+52 728 2843185

Send message

See all contacts

MX(ES)

smart plastics in aluminium oxide production | igus

Specification

During the mining and subsequent storage of bauxite, a sedimentary rock for the production of aluminium oxide, a lot of dust is thrown up, which is a major challenge especially for the moving machine parts of the conveyor units. For this reason, Aluminium Oxid Stade GmbH (AOS), one of the major German alumina producers, decided to use smart energy chains, which are equipped with push/pull detection.
At AOS, the smart energy supply system is used three times. One is in a hall, where the dust load is at a maximum, and the other two applications are outdoors. However, the outdoor applications are characterised by a maximum travel length of 330 m.

More about technology

The challenge

The heavy dust arising during the movement of bauxite is an enormous stress, especially for moving machine components. Before the energy chains, motor cable drums were used for the energy supply. The problem with the energy supply through the motor drums was that the cables were not always reeled in correctly, which ultimately resulted in machine breakdowns due to cable damage.
In addition to plant safety, safety for people plays an even greater role. Before the smart e-chain® was installed, in the event of crane failures or for maintenance purposes, you always had to climb 40 metres up the crane with a laptop to read the data. This was also always associated with a certain risk for humans.

Solution

The first decision in favour of a smart energy supply system from igus was made back in 2012, when the push-pull force measurement was still called PPDS (push/pull detection system). Now this technology is called EC. P (e-chain pull detection), which is much more space-saving and easier to install than before. AOS uses the EC. P System as a cleaning or maintenance reminder and states:"If the chain's travel becomes too obstructed by dust and dirt, the pull/push force detection system shuts the system down before damage occurs and we know it's time to clean the chain's travel again."
This is called "killing two birds with one stone", because expensive damage is avoided and you always know when it is time to clean the machine from dust and dirt. Simply smart.

"Less maintenance, higher availability, the possibility of routing all the different cables and hoses in one system, the electronic push/pull force monitoring ... all these advantages have fully convinced us of igus. I would always use igus energy chains again!"

Dipl.-Ing. Fabian Wilhelm, Project Manager of AOS Stade